College Station · Georgetown · Weatherford

Finish carpentry, trim and wood rot repair

Baseboard, casing, crown, shelving and built-ins — plus the rot repair that finish work usually uncovers. Tight joints, filled nail holes, caulked seams, ready for paint.

What we handle

Trim that reads as part of the house.

Finish carpentry is judged from six feet away in bad light.

Baseboard and casing

Replace builder-grade with a taller profile, or repair what is there. Scribed to the floor, mitred tight, nail holes filled and seams caulked.

  • Full-room or whole-house runs
  • Door and window casing
  • Scribed to uneven floors

Crown and ceiling trim

Rooms, halls and stepped ceilings. Inside corners coped rather than mitred, because coped joints stay shut when the house moves.

  • Coped inside corners
  • Stepped and vaulted ceilings
  • Returns cut, not caulked shut

Built-ins and shelving

Closet systems, alcove builds, window seats and office walls. Square, level, fastened to framing and left paint-ready.

  • Alcove and closet builds
  • Floating and face-framed shelving
  • Paint-ready finish

Wood rot repair

Fascia, soffit, door jambs, window trim, porch posts and column bases. Rotten sections cut back to sound wood, replaced, primed on all faces and sealed.

  • Fascia and soffit sections
  • Jambs and brickmould
  • Porch posts and column bases
Where we stop

Licensed trades go to licensed trades.

We don't do electrical, plumbing or locksmith work. We work alongside licensed electricians and plumbers and bring the right one in when your job needs it.

How it works

From your list to done.

01

Tell us what you need

Tell us what needs doing, which town you are in, and send photos if you have them.

02

Free written estimate

You get a written estimate before anyone picks up a tool. Free, and there's no obligation to book it.

03

We book the visit

Approve the estimate and we book the visit.

What it costs

What it costs.

This work is quoted job by job on a free written estimate. Where a list of smaller items is the better fit, it can be booked as a block of time instead.

Published rates

Hourly rate $125
Half day — four hours $460
Full day — eight hours $840
Finish Carpentry FAQ

What people ask about this work.

We can, and most people want it. Bare trim gets primed and finish-coated; existing trim gets filled, caulked and touched in. Say whether paint is included when you ask for the estimate so the number is the real number.
Often. Stock profiles cover a lot of houses, and where the profile is discontinued we can build it up from two or three pieces to match the look. If it cannot be matched we will show you the closest option before ordering anything.
We stop and show you. Rot is normally bigger than the visible spot, so we cut back to sound wood and measure the real extent.
Usually water sitting somewhere it should run off — a failed caulk joint, a gutter overflowing behind fascia, or bare end-grain that was never primed. We fix the wood and point out the cause, because replacing the board alone just resets the clock.

Do you work in my town?

We work in College Station, Georgetown and Weatherford, Texas. The service-area page lists what each of the three covers.

See the service area

The full handyman scope

Trim work pairs with painting, doors and drywall. All fifteen categories go on one written estimate.

See all services

Trim, built-ins or rot repair?

Send photos and rough measurements, and say which town you are in.

Contact

What are we building?

Photos of the existing trim and a rough measurement are enough to start. Rot repair we prefer to look at.

Get a free estimate

Tell us what's on the list.